Let the hive mind of Engadget get that for you.
"I finally got a new laptop with a lone USB 3.0 port. I'm now looking at getting a USB 3.0 hub with a power adapter so I can use both of my USB 3.0 hard drives at faster speeds. I've read lots of horror stories where some hubs either don't come with power adapters -- and as a consequence the portable drives don't work with them properly -- or they are designed poorly which results in USB 2.0 speeds. Or, the hard drives keep getting disconnected. Do your readers have any suggestions or experience using USB 3.0 hubs? Thanks!"
Ok well i am a first time poster and i dont know how to start these things out sooooo..i got a question. I am an amature solderer and this is my first time modding anything and so far so good. Now when i install the tact switches on the pcb board u just glue it on there right? And also how do you get the led ring so clean with your welds and also should i insulate the welds with a small amount of hot glue?